| 1963-1979 Corvette 1350 Series Flange Yoke | ||||||
| Part #: Corv-FL1350 | $45.95 each | |||||
|
Brand new Spicer 1350 series flange yoke to replace your bent, rusted or damaged original equipment rear axle half shaft flange yoke. |
||||||
2 required per vehicle
|
Status: In Stock, Usually Shipped Within 2 Days
$45.95 each
|
|||||
|
Brand new Spicer 1350 series flange yoke to replace your bent, rusted or damaged original equipment rear axle half shaft flange yoke. Installation Tip: When changing a flange yoke on any 1963-1979 Corvette half shaft you should be carefull to never strike the flange yoke or driveshaft with a hammer. The u-joint must be pressed into place and care must be given not to ever squeeze the driveshaft tubing in a vise. This will cause permanent damage! Also a Corvette flange yoke can be bent if not supported properly while pressing the u-joint into place. The best way to achieve this is to bolt the flat flange surface to a heavy piece of steel plate so it cannot bend while you are working on it. |
||||||
|
||||||
Complementary Product Suggestions
|
||||||
|
||
