|
Denny's part number X-1574
Aluminum Urethane mounted center support bearing
WILL NOT FIT STOCK DRIVESHAFT
Can be used on 3 inch diameter custom built 1350 series 2 piece driveshafts that require a 1.574 ID bearing
- Ideal for building larger and stronger two piece driveshaft in 1310 or 1350 series
- Bearing ID is 1.574 for use with custom built aftermarket driveshaft
- Must be used with spline and slip style rear driveshaft section
- Aluminum Mounting fits Chevrolet Car frame
- 1958, 1959, 1960, 1961, 1962, 1963, 1964
- Aluminum Mounting fits Chevy C-10 1/2 Ton Truck frame
- 1960, 1961, 1962, 1963, 1964, 1965, 1966, 1967, 1968, 1969, 1970, 1971, 1972
Super Strong aircraft aluminum housing will not bend or twist.
- Bearing is suspended in Urethane and will not pull out under load like the original rubber mount did when it distorted under load.
- This could be the cure that you have been looking for to end all your problems with center hanger bearing failure
- Great for cars and trucks with hydraulic suspensions
- Comes with Mounting Bolts and washers
|
