STR-3 Camaro Driveshaft 3 inch Diameter Tube with SPICER 1310 series slip yoke and universal joints ALL years with 3 7/32 inch wide rear u-joint

STR-3 CAMARO DRIVESHAFT 3 inch diameter fits all with 1310 Rear U-joint

Part Number:
STR-3

UPC:

Your Cost $525.95

STATUS: CUSTOM BUILT - 5 WEEK BACKLOG ON NEW ORDERS

STR-3

CAMARO DRIVESHAFT 1310 Series .... 3 inch Diameter Tube

Built with 3.0 inch tube for extra strength and reliability.
"If you ever twist our Heavy Duty Driveshaft tubing or break our welds....we'll replace it FREE"
Custom Built to fit all 10 Bolt or 12 Bolt with 3 7/32 inch wide Rear Universal Joint
Comes with 1310 Series SPICER Solid Body Universal Joints
Comes with 27 or 32 Spline SPICER Slip Yoke

STR-3 CAMARO DRIVESHAFT 3 inch diameter fits all with 1310 Rear U-joint

Click for Larger Photo

STATUS: CUSTOM BUILT - 5 WEEK BACKLOG ON NEW ORDERS

YOUR COST: $525.95

OVERSIZE PACKAGE: Sorry ... this item DOES NOT qualify for Free Shipping!

STR-3

CAMARO DRIVESHAFT with transmission slip yoke and u-joints. 1310 series for 27 spline or 32 spline automatic or manual transmission. High Speed - HIGH RPM balanced and tested to be sure it will perform smoothly in your Camaro.

For STREET use and occasional strip use up to 500 horsepower
3 inch OD Tubing
- "If you ever twist our Heavy Duty Driveshaft tubing or break our welds....we'll replace it FREE"
Custom Built to fit all 10 Bolt or 12 Bolt with 3 7/32 inch wide Rear Universal Joint
- 1310 Series (3 7/32 wide with 1 1/16 bearing caps) SPICER Non Greaseable U-Joints
SPICER 1310 Series Transmission SLIP YOKE....Please specify transmission and spline count when ordering
- 27 spline slip yoke for Powerglide, T-350, Muncie M20 M21 or M22 or other 27 spline Trans
- 32 spline slip yoke for T-400, Muncie, Borg Warner Super T-10 or other 32 spline Trans
High Speed - High RPM Balanced
Tested to be sure it will perform smoothly at all road speeds
Click Here for Diagram "B" ....use this one to order a driveshaft

MEASUREMENTS REQUIRED TO ORDER THIS SHAFT

STR-3 CAMARO DRIVESHAFT 3 inch diameter fits all with 1310 Rear U-joint

Enter your email address and we'll send you a message when this item is available

Please enter your email address in order to be notified when this item is available.

[ X ]

Chevrolet > CAMARO 1967 to 2002 > Driveshafts 1967 to 2002 > 1310 SERIES

Enter your email address and we'll send you a message when this item is available