Denny's AL3.5-1350-62CM Aluminum Driveshaft with Mark Williams Chromoly slip yoke 3.5 inch 1350 series custom built 57 to 62 inch CL
|
Part Number: AL3.5-1350-62CM
|
Your Cost
$995.95
STATUS:
CUSTOM BUILT - 5 WEEK BACKLOG ON NEW ORDERS
|
|
AL3.5-1350-62CM
1350 Aluminum Driveshaft
- Aluminum Driveshaft custom built to fit your vehicle
- 1350 series
- 3.5 inch OD - 0.125 wall thickness - KDS4-T8 ALUMINUM - Surpasses ASTMB210 specification
- Comes with 1350 series Mark Williams Chromoly Transmission Slip Yoke
- Comes with 1350 series Dana Spicer u-joints - NON Greaseable SOLID BODY
- High Speed - High RPM Balanced and tested to be sure it will perform smoothly at all road and track speeds
- Complete driveshaft fully assembled and ready to install
- Requires 1350 Pinion Yoke
UPC:
Part Number: AL3.5-1350-62CM
|
Denny's AL3.5-1350-62CM Aluminum Driveshaft with Mark Williams Chromoly slip yoke 3.5 inch 1350 series custom built 57 to 62 inch CL
|
STATUS: CUSTOM BUILT - 5 WEEK BACKLOG ON NEW ORDERS
YOUR COST:
$995.95
|
AL3.5-1350-62CM
1350 Aluminum Driveshaft
- Aluminum Driveshaft custom built to fit your vehicle
- 1350 series
- 3.5 inch OD - 0.125 wall thickness - KDS4-T8 ALUMINUM - Surpasses ASTMB210 specification
- Comes with 1350 series Mark Williams Chromoly Transmission Slip Yoke
- Comes with 1350 series Dana Spicer u-joints - NON Greaseable SOLID BODY
- High Speed - High RPM Balanced and tested to be sure it will perform smoothly at all road and track speeds
- Complete driveshaft fully assembled and ready to install
- Requires 1350 Pinion Yoke
- Limited to 62 inch Center to Center
- On Diagram "B" your overall length dimension "Number B6" should be approximately 65 inches or less
|
OVERSIZE PACKAGE: Sorry ... this item DOES NOT qualify for Free Shipping!
|
Denny's AL3.5-1350-62CM Aluminum Driveshaft with Mark Williams Chromoly slip yoke 3.5 inch 1350 series custom built 57 to 62 inch CL
|
|