350083-377 Spline and Slip yoke set 1350 series fits 3.5 inch 0.083 wall steel tube allows maximum 3 inches of slip travel

Part Number:
350083-377

UPC:

Your Cost $145.95

STATUS: IN STOCK - FREE SHIPPING

350083-377

Spicer Spline and Slip yoke set

Fits 3.5 inch steel tube OD with 0.083 wall thickness
Fits 1350 series universal joint (see choices at bottom of page)
- 3.625 wide cap to cap
- 1.188 cap diameter
- outside snap rings
Maximum of 3 inches slip travel
Spicer Slip yoke 1.500 x 16 splines, grease fitting in slip yoke barrel, has screw on seal
Spicer Spline is glidecoated (blue coating) 2.500 inches for wear resistance if properly lubricated
- Spline butt diameter to press fit into tube - 3.345 inches

350083-377 Spline and Slip yoke set 1350 series fits 3.5 inch 0.083 wall steel tube allows maximum 3 inches of slip travel

Click for Larger Photo

FOR FASTER SERVICE, PLEASE ORDER ALL PARTS ONLINE

STATUS: IN STOCK - FREE SHIPPING

YOUR COST: $145.95

350083-377

Spicer Spline and Slip yoke set

Fits 3.5 inch steel tube OD with 0.083 wall thickness
Fits 1350 series universal joint (see choices at bottom of page)
- 3.625 wide cap to cap
- 1.188 cap diameter
- outside snap rings
Maximum of 3 inches slip travel
Spicer Slip yoke 1.500 x 16 splines, grease fitting in slip yoke barrel, has screw on seal
Spicer Spline is glidecoated (blue coating) 2.500 inches for wear resistance if properly lubricated
- Spline butt diameter to press fit into tube - 3.345 inches

The following dimensions are taken with the supplied seal installed.

**CL to weld Collapsed Dimension - 8.50 inches
**CL to weld Dimension at MID travel - 10.312 inches
CL to weld Fully Extended Dimension - 12.00 inches

**Caution --- Using a rubber boot in place of the seal will lengthen the collapsed and mid point dimensions. You must factor this into your build dimensions before cutting, welding and building the driveshaft

Copywrite Denny's Driveshafts

350083-377 Spline and Slip yoke set 1350 series fits 3.5 inch 0.083 wall steel tube allows maximum 3 inches of slip travel

You May Also Need These Parts to Complete the Job

Dana Spicer 5-178X Greaseable u-joint 1350 Series Part#: 5-178X $20.95	Dana Spicer 5-1350-1X GREASEABLE Universal Joint 1350 Series fitting in end of bearing cap Part#: 5-1350-1X $32.60
Dana Spicer 5-1350X Universal Joint NON Greaseable 1350 series cold forged solid body heat treated precision ground and case hardened with multi lip seals Part#: 5-1350X $23.54

Enter your email address and we'll send you a message when this item is available

Please enter your email address in order to be notified when this item is available.

[ X ]

Driveshaft and Driveline Parts > SPLINE / SLIP YOKE MATCHED SETS > Fits 3.5 inch OD Steel Tube > With 1350 Slip Yoke

You May Also Need These Parts to Complete the Job

Enter your email address and we'll send you a message when this item is available