Part number: 1310SS-25864 Driveshaft REAR SECTION Spline & Slip Style for 58-64 Chevy and 55-72 Trucks

Part Number:
1310SS-25864

UPC:

Your Cost $345.95

STATUS: PLEASE CALL TO ORDER

Part number: 1310SS-25864

Spline and Slip Style REAR SECTION for 2 piece driveshaft...
2 inch tube diameter. Same diameter as original
Great for Hydraulic or Air Ride suspensions!

Part number: 1310SS-25864 Driveshaft REAR SECTION Spline & Slip Style for 58-64 Chevy and 55-72 Trucks

Click for Larger Photo

STATUS: PLEASE CALL TO ORDER

YOUR COST: $345.95

Part number: 1310SS-25864

Heavy duty Spline and Slip Style REAR SECTION for 2 piece driveshaft...2 inch tube diameter. Replace your original equipment style rear section of your 2 piece driveshaft with a better design and eliminate center bearing damage. Designed with a spline and slip to allow for suspension movement when using hydraulics or air ride suspensions. The forward and back movement of the driveshaft within the original equipment design rubber center support can ruin it quickly. Adding this rear section and a urethane center support bearing will eliminate that problem forever.

REAR SECTION ONLY...comes with spline, slip yoke and (2) Spicer u-joints
2 inch OD tube diameter
1310 Series
High Speed Balanced
Custom Built to your exact length....whether in a car or light truck application.
IMPORTANT: Please measure Center of u-joint to Center of u-joint on your existing driveshaft rear section to place your order.
Painted Black
Comes assembled with Spicer u-joints to match original equipment size
Aluminum Urethane Center Support Bearing sold separately.

MEASUREMENTS ARE REQUIRED TO ORDER THIS SHAFT

OVERSIZE PACKAGE: Sorry ... this item DOES NOT qualify for Free Shipping!

Part number: 1310SS-25864 Driveshaft REAR SECTION Spline & Slip Style for 58-64 Chevy and 55-72 Trucks
Click Here to Enlarge	Click Here to Enlarge

You May Also Need These Parts to Complete the Job

X-1 Center Support with stock 1.181 bearing ID Aluminum Urethane Mount for 1958 to 1964 Chevy Car and 1960 to 1972 C-10 Truck must be used with spline and slip rear driveshaft only
Part#: X-1

$125.95

Enter your email address and we'll send you a message when this item is available

Please enter your email address in order to be notified when this item is available.

[ X ]

Chevrolet > 1958 to 1964 CHEVY CAR - 1960 to 1972 C-10 TRUCK > DRIVESHAFT REAR SECTION

You May Also Need These Parts to Complete the Job

Enter your email address and we'll send you a message when this item is available