Product Search

Denny's Driveshaft builds custom steel and aluminum driveshafts for your high performance car, street rod, race car, van, pick up or 4x4 truck

FREE
GROUND
SHIPPING on Parts Orders
Over $99.00

Measuring Diagrams

How to Measure Correctly

Driveshafts

1350 Nitrous Ready Driveshafts Street Rod Driveshafts Street Rod HD Driveshafts Aluminum 6061-T6 Driveshafts Cobra Kit Car Driveshafts 4x4 TRUCK Driveshafts 2WD TRUCK Driveshafts

Shop By Vehicle Type

CHEVROLET - Parts BUICK - Parts PONTIAC - Parts OLDSMOBILE - Parts DODGE - MOPAR Parts JEEP - Parts FORD - Parts LINCOLN - Parts

Driveline Parts

• AXLE DIFF - 4X4 FRONT DIFF PARTS • AXLE DIFF - REAR END PARTS • AXLE SHAFTS REAR DIFF • BALL JOINTS / KING PIN PARTS • BEARINGS - DIFFERENTIAL KITS • BEARINGS - Driveshaft Center Support • BEARINGS - Sets - Cups - Cones - Needle • BUILD IT YOURSELF - PARTS LISTS • BUSHINGS TO ADAPT TUBE SIZE • COMPANION FLANGES • CRUSH SLEEVE - Collapsable Spacer • CV BALL STUD YOKES Double Cardan • CV PARTS - Double Cardan Driveshaft • DIFF COVERS, BOLTS, GASKETS • DIFFERENTIAL PARTS - FRONT / REAR • DIFFERENTIAL PARTS - POSITRACTION • DUST CAPS - SEALS - RUBBER BOOTS • FLANGE YOKES • GEARS - Ring and Pinion • GIFT CERTIFICATES • HARDWARE - U-Bolts, Straps, Nuts more • INFO LIBRARY • LUBRICANTS - Grease • PARTS - AAM Driveshaft and Axle • PARTS - ALL Driveshaft and Driveline • PARTS - NEAPCO by Part Number • PARTS - NEW ARRIVALS • PARTS - YUKON • PINION NUTS and WASHERS • PINION YOKES FRONT or REAR END • PTO PARTS Power Take Off and AG • RING GEAR BOLTS • SEALS - Oil and Grease • SHIMS, BAFFLES, SLINGERS • SLIP YOKES - AAM ONLY • SLIP YOKES - CHROMOLY • SLIP YOKES - DANA SPICER ONLY • SLIP YOKES - DOUBLE CARDAN CV • SLIP YOKES - Driveshaft Spline/Slip • SLIP YOKES - T400, 4L80 TRUCK TRANS • SLIP YOKES - TRANSFER CASE • SLIP YOKES - TRANSMISSION Auto/Man • SPINDLE NUTS, WASHERS, STUDS • SPINDLES 4x4 FRONT • SPLINE / SLIP YOKE MATCHED SETS • SPLINES - Center Brg Bolt On Yoke Style • SPLINES - Center Brg Slip Yoke Style • SPLINES - DANA SPICER ONLY • SPLINES - Use with Slip Yoke • TRANSFER CASE END YOKE - BOLT ON • TRANSMISSION END YOKE - BOLT ON • TUBING - ALUMINUM DRIVESHAFT • TUBING - STEEL DRIVESHAFT • UNIVERSAL JOINTS - 4X4 AXLE • UNIVERSAL JOINTS - Car and Light Truck • UNIVERSAL JOINTS - CONVERSION • UNIVERSAL JOINTS - HD TRUCK and EQUIP • WELD YOKES - ALUMINUM • WELD YOKES - STEEL

Product Search

Free Shipping on Parts Orders Over $99.00

Customer Testimonials

I ordered a tough to get driveshaft slide collar from Denny's. When the delivery would be delayed because of manufacturer's shortage (thanks, Covid), Denny personally gave me a call to make sure the timing would be sufficient to get my combine back in...
...read more

Adam B ~ Decatur , IL

Click here to send us your testimonial

CV STUD YOKE, H YOKE AND CENTERING YOKE

Dana Spicer 212024X CV Flange Yoke 1350 Series Double Cardan fits FORD transfer case with 2 inch pilot

Part Number:
212024X

UPC:

023913229542

Your Cost $91.95

STATUS: IN STOCK

DANA SPICER 212024X

Double Cardan CV Flange Yoke
1350 Series
Fits FORD 4X4 transfer case with 2 inch pilot

DOES NOT FIT any greaseable style 1350 series stud yokes
DOES NOT FIT OEM Driveshaft with press on ball.
- Please see the bottom of this page for new rubber boot

Dana Spicer 212024X CV Flange Yoke 1350 Series Double Cardan FORD transfer case with 2 inch pilot

Click for Larger Photo

FOR FASTER SERVICE, PLEASE ORDER ALL PARTS ONLINE

STATUS: IN STOCK

YOUR COST: $91.95

DANA SPICER 212024X

Double Cardan CV Flange Yoke
1350 Series
Fits FORD 4X4 transfer case with 2 inch pilot
- 4 Mounting holes are THREADED to accept OEM Ford bolts
- Bolt Pattern.... 4.25 inches measured diagonally
- Pilot Diameter... 2 inches
- Needle Bearing Ball Socket fits 1/2 inch stud yoke
- NON greaseable Maintenance Free
- Comes with New Spring included
- Dimension between outside snap rings...(3.625 inches) 3 5/8 inches
- Designed to fit (1.187 inches) 1 3/16 inch U-Joint Bearing cap
- DOES NOT FIT any greaseable style 1350 series stud yokes
- DOES NOT FIT OEM Driveshaft with press on ball.

Use with 1350 Series U-Joints listed below.

IMPORTANT: The "SPICER" name must be visible on your original H-Yoke and Flange yoke to use these replacement parts.

If you have a driveshaft that looks like the one in these photos then this cv will NOT work.

Please notice the shape of the mounting flange...if yours looks like the mounting flange in the photo on the left then this CV will not fit.
Please notice the squared shape of the H-Yoke around the holes for the u-joint cap and snap ring in the photo on the right. ... If yours has the squared shape then this CV will not fit.
If you have a driveshaft with a pressed on ball on the cv stud yoke then this cv will NOT work.

Dana Spicer 212024X CV Flange Yoke 1350 Series Double Cardan FORD transfer case with 2 inch pilot

You May Also Need These Parts to Complete the Job

42-1855 BOLT Set M12-1.75 for Ford Transmission/Transfer Case Flange - 12mm 12 point bolt set Part#: 42-1855 $11.95	Neapco 2-0053G universal joint 1350 Series non greaseable 3.622 x 1.188 Part#: 2-0053G $27.95
DE-15688 Installation Tool for use with Rubber Boot Part Number 2-86-418 Part#: DE-15688 $32.95	Dana Spicer 5-178X Greaseable u-joint 1350 Series Part#: 5-178X $20.95
Dana Spicer 5-1350-1X GREASEABLE Universal Joint 1350 Series fitting in end of bearing cap Part#: 5-1350-1X $32.60	Dana Spicer 5-1350X Universal Joint NON Greaseable 1350 series cold forged solid body heat treated precision ground and case hardened with multi lip seals Part#: 5-1350X $23.54
DANA SPICER 2-86-418 Rubber Boot for Ford OEM Non Greaseable CV Centering Yoke Part#: 2-86-418 $7.25	Dana Spicer 3-26-757 CV "H" Yoke 1350 Series for FORD Part#: 3-26-757 ~~$50.95~~ $45.95
NEAPCO N3-26-757 CV "H" Yoke 1350 Series for FORD Part#: N3-26-757 $57.95